Update Ktag Clone From 225 To 270 Direct

Connect the other end of these wires to your J-Link programmer, then plug the J-Link into your computer via USB. Provide stable 12V external power to the KTAG unit using its wall adapter. Step 3: Flash Firmware 7.020 via J-Flash Open the software on your PC.

Make a folder on your desktop: KTAG_2.70_Update Inside, place: update ktag clone from 225 to 270

: Always use a stable power supply for your KTAG device during the update to prevent bricking the hardware. Connect the other end of these wires to

Unscrew the KTAG casing and carefully remove the main PCB board. Locate the central microcontroller chip. Make a folder on your desktop: KTAG_2

Note: The hardware inside your clone (the green or blue PCB) remains the same. You are updating the firmware on the card and the software on your PC.

Windows 7 (32-bit or 64-bit) or Windows 10 (64-bit clean installation).