Erickhill Rt-100 User Manual !!hot!! Instant

Position the meter within 5–10 cm during active data transmission or calls to observe peak high-frequency electric field spikes.

Are you trying to interpret a you just saw on the screen? Share public link erickhill rt-100 user manual

0.01 μT to 99.99 μT / 0.1 mG to 999.9 mG (Accuracy: 0.01 μT / 0.1 mG; Alarm Threshold: 0.4 μT / 4.0 mG) Frequency Bandwidth: 5 Hz to 3500 MHz Sampling Time: Approximately 0.4 seconds Display: 3.5-digit LCD screen with backlight Operating Temperature: 0°C to 50°C (32°F to 122°F) Operating Humidity: Relative humidity below 80% Position the meter within 5–10 cm during active

Allows you to lock the current reading on the screen or capture the highest detected value. Sound-Light Alarm: When the radiation exceeds the safe threshold ( ), the device beeps and the screen backlight turns red. Backlit LCD: Sound-Light Alarm: When the radiation exceeds the safe

When you open the box, you will find the Erickhill RT-100 EMF meter, a USB charging cable, and a basic quick-start leaflet.

Congratulations on acquiring the Eric Hiller RT-100, a state-of-the-art two-way radio designed for reliable communication in various environments. This user manual will guide you through the features, operations, and maintenance of your new device, ensuring you get the most out of your Eric Hiller RT-100.

| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Low battery | Connect the provided USB charge cable. The battery can last 8+ hours on a full charge. | | No beeping sound | Buzzer turned off | Long press the middle (AVG/Peak) button to re-enable the buzzer. | | Magnetic field reading looks wrong | Wrong unit selected | Check if you are reading µT vs mG. Short press the bottom button to switch. | | Screen stuck on one number | Data Hold (HOLD) is on | Press the power button once to release the hold. | | Device turns off by itself | Normal operation | The 5-minute Auto Power Off is a battery-saving feature, not a defect. |