The pins are made of copper with a tin plating and can be soldered to wires or directly to a PCB. However, because the substrate is thin and flexible, soldering temperatures should be kept as low as possible (recommended below 300 °C, with a short dwell time) to avoid damaging the film.
However, I can give you to help you locate the official datasheet or verify the part. zd10-100 datasheet
to an analog pin (e.g., A0) on your microcontroller (e.g., Arduino, ESP32). The pins are made of copper with a
Flexible Thin Film Pressure Sensor. ZD10-100. Project. Size parameter. Product size. Thickness. Range. Response point. Durability. SENSOR+TEST to an analog pin (e
The data outlined below reflects standard operating parameters compiled from industrial component documentation. Specification Value Notes / Operating Conditions 0 to 500 g Optimized for low-mass/light touch profiles Thickness ≤is less than or equal to 0.25 mm to 0.30 mm Ultra-low profile component Response Point ≤is less than or equal to 20 g to 50 g Force threshold required to trigger transition Initial Resistance Open-circuit value with zero load applied Test Voltage 3.3 V DC (Typical) High compatibility with low-power MCUs Response Time Extremely rapid state transition Recovery Time Durability Lifecycle Actuations before performance degradation Operating Temperature -20°C to 60°C Rated for standard industrial environments EMI / ESD Sensitivity None / Insensitive Immune to high electromagnetic interference Mechanical Dimensions & Form Factor Go to product viewer dialog for this item.
: The best place to start is the website of the manufacturer. If you know who made the ZD10-100, visit their site and use the search function. Common manufacturers include ON Semiconductor, NXP, STMicroelectronics, and Vishay.