Caselabs Sma8 Manual -

Because of this variability, a generic assembly guide doesn’t exist. The original manual was a simple, black-and-white pamphlet showing basic screw placement, but it assumed you knew which configuration you purchased.

Lay the motherboard tray flat. Install brass standoffs matching your form factor (SSI-EEB, E-ATX, ATX, or Micro-ATX). caselabs sma8 manual

The manual highlights space for E-ATX motherboards and multiple long graphics cards. 4. Revision A Improvements Because of this variability, a generic assembly guide

Use a precision screwdriver set to remove the side, top, and front panels. Keep your screws organized in a magnetic tray. Step 2: Motherboard Tray Installation Install brass standoffs matching your form factor (SSI-EEB,

The front I/O (USB 3.0, Audio, Power button) is wired via a Lian-Li style connector block. If your manual is missing, note that the Power Switch uses a standard 2-pin header (PWR_BTN), but the HDD LED uses a non-standard small gauge wire—handle with care.

If using a single PSU, install the included blanking plate over the secondary cutout to prevent dust ingestion. Drive Bay Assembly

Position the at the opposite end. Secure it firmly to the base. Step 2.3: Dropping the Top Panel and Squaring the Chassis